Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Mode Commands
s1-mme sctp port ▀
Command Line Interface Reference, StarOS Release 18 ▄
7413
s1-mme sctp port
Configures the source Stream Control Transmission Protocol (SCTP) port that will be used for binding the SCTP socket
to communicate with the eNodeB using S1AP with this MME service.
to communicate with the eNodeB using S1AP with this MME service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
s1-mme sctp port port_num
default s1-mme sctp port
default
Sets the SCTP port to the default value of 36412 to communicate with the eNodeBs using S1-MME interface.
port_num
Specifies the SCTP port number to communicate with the eNodeBs using S1-MME interface as an integer
from 1 through 65535. Default: 36412
from 1 through 65535. Default: 36412
Usage
Use this command to assign the SCTP port with SCTP socket to communicate with the eNodeB using S1AP.
Only one SCTP port can be associated with one MME service.
Only one SCTP port can be associated with one MME service.
Example
The following command sets the default SCTP port number 699 for to interact with eNodeB using S1AP on
S1-MME interface:
S1-MME interface:
default s1-mme sctp port