Cisco Cisco Packet Data Gateway (PDG)
MME SGs Service Configuration Mode Commands
▀ pool-area
▄ Command Line Interface Reference, StarOS Release 18
7426
pool-area
Creates a location area code (LAC) pool area configuration or specifies an existing pool area and enters the LAC Pool
Area Configuration Mode.
Area Configuration Mode.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME SGs Service Configuration
configure > context context_name > sgs-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgs-service)#
Syntax
[ no ] pool-area pool_name [ -noconfirm ]
no
Removes the selected pool area configuration from the SGs service.
pool_name
Specifies the name of the LAC pool area configuration. If
pool_name
does not refer to an existing pool, a
new pool is created.
pool_name
must be an alphanumeric string of 1 through 64 characters.
Usage
Use this command to enter the LAC Pool Area Configuration Mode for an existing pool area configuration or
for a newly defined pool area configuration. This command is also used to remove an existing pool area
configuration.
In Release 12.2 and later, a maximum of 48 combined pool areas and non pool areas can be created. In older
releases, a maximum of 8 combined pool areas and non pool areas can be created.
Entering this command results in the following prompt:
for a newly defined pool area configuration. This command is also used to remove an existing pool area
configuration.
In Release 12.2 and later, a maximum of 48 combined pool areas and non pool areas can be created. In older
releases, a maximum of 8 combined pool areas and non pool areas can be created.
Entering this command results in the following prompt:
[context_name]hostname(config-sgs-pool-area)#
LAC Pool Area Configuration Mode commands are defined in the MME LAC Pool Area Configuration Mode
Commands chapter.
Commands chapter.
Example
The following command enters the LAC Pool Area Configuration Mode for a new or existing pool area
configuration named
configuration named
pool1
:
pool-area pool1