Cisco Cisco Packet Data Gateway (PDG)
Command Line Interface Reference, StarOS Release 18 ▄
7895
Chapter 258
PDG Service Configuration Mode Commands
The PDG Service Configuration Mode is used to specify the properties required for the UEs in the WLAN (Wireless
Local Access Network) to interface with the Packet Data Gateway/Tunnel Termination Gateway (PDG/TTG).
Local Access Network) to interface with the Packet Data Gateway/Tunnel Termination Gateway (PDG/TTG).
Mode
Exec > Global Configuration > Context Configuration > PDG Service Configuration
configure > context context_name > pdg-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pdg-service)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).