Cisco Cisco Packet Data Gateway (PDG)

Seite von 9109
Policy Control Configuration Mode Commands   
▀  diameter sgsn-change-reporting 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
8110 
   
diameter sgsn-change-reporting 
This command enables reporting of SGSN_CHANGE event trigger and SGSN-Address AVP for 2G and 3G calls on 
GnGp P-GW. 
Product
 
GGSN 
P-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > IMS Authorization Configuration > Policy Control 
Configuration 
configure > context context_name > ims-auth-service service_name > policy-control
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-imsa-dpca)# 
Syntax
 
diameter sgsn-change-reporting 
no diameter sgsn-change-reporting 
sgsn-change-reporting
 
This keyword specifies to detect SGSN change and send SGSN-Address AVP and SGSN_CHANGE event 
trigger for a subscriber in 2G/3G on Gx interface during GnGp scenario. 
no
 
This variant specifies to send AN-GW-Address AVP during the call setup, when SGSN change happens, or 
during the handoff from 4G to 3G. This is the default setting. 
Usage 
The current implementation does not send SGSN_CHANGE event trigger and SGSN- Address AVP. Instead 
it sends AN-GW-Address AVP and AN_GW_CHANGE event trigger for GnGp case. This behavior is not 
compliant to 3GPP standard TS 29.212 specification. Hence, in release 18, this CLI command “
diameter 
sgsn-change-reporting
” has been introduced to control this behavior.  
This release provides, the GnGp P-GW users, the flexibility to configure detection of SGSN_CHANGE event 
trigger and to send SGSN-Address AVP for a subscriber in 2G/3G on Gx interface, so that PCRF can use this 
information to apply appropriate policies.  
In releases prior to 18, AN-GW-Address AVP was sent in CCR-I message on GnGp scenario. 
AN_GW_CHANGE event trigger and AN-GW-Address AVP were sent when the inter-sgsn handoff or 4G to 
2G/3G GnGp handoff happens. 
When this CLI command is configured, SGSN-Address AVP will be sent in the CCR-I message for 2G/3G 
GnGp P-GW subscribers. SGSN_CHANGE event trigger and SGSN-Address AVP will be sent when the 
inter-sgsn handoff or 4G to 2G/3G GnGp handoff happens.