Cisco Cisco Packet Data Gateway (PDG)
Route-map Configuration Mode Commands
▀ match ip address
▄ Command Line Interface Reference, StarOS Release 18
8362
match ip address
Matches IPv4 routes with entries in a route-access-list or prefix-list.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Route-map Configuration
configure > context context_name > route-map map_name { deny | permit }
seq_number
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-route-map)#
Syntax
[ no ] match ip address { prefix-list | route-access-list } list_name
no
Disables matching from the specified prefix list or route access list.
prefix-list
Matches any routes with entries in a prefix-list.
route-access-list
Matches any routes with entries in a route-access-list.
list_name
Specifies the name of the IPv4 prefix list or IPv4 route access-list as an alphanumeric string of 1 through 79
characters.
characters.
Usage
Use this command to match routes specified in an IPV4 route-access-list or prefix-list.
Example
To match routes that are specified in an IPv4 prefix list named Prefix100, enter the following command:
match ip address prefix-list Prefix100