Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
▀ bfd-mon-ignore-dead-interval
▄ Command Line Interface Reference, StarOS Release 18
8468
bfd-mon-ignore-dead-interval
Causes the standby ICSR chassis to ignore the dead interval and remain in the standby state until all the BFD chassis-to-
chassis monitors fail.
chassis monitors fail.
Product
All products that support ICSR.
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
bfd-mon-ignore-dead-interval
default bfd-mon-ignore-dead-interval
default
Disables this feature.
Usage
Enable this feature in association with BFD chassis-to-chassis monitoring to support more aggressive ICSR
failure detection times.
For additional information, see the descriptions of the dead-interval and monitor bfd commands.
failure detection times.
For additional information, see the descriptions of the dead-interval and monitor bfd commands.
Example
The following command enables this feature:
bfd-mon-ignore-dead-interval