Cisco Cisco Packet Data Gateway (PDG)
S-GW Service Configuration Mode Commands
▀ timeout idle
▄ Command Line Interface Reference, StarOS Release 18
8738
timeout idle
This command removes S-GW sessions that remain idle for longer than the configured time limit.
Product
S-GW
SAE-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
timeout idle dur_seconds [ micro-checkpoint-periodicitytime_in_seconds ]
{ default | no } timeout idle
default
Indicates the timeout specified is to be returned to its default behavior.
no
Disables the timeout idle functionality.
timeout idle
Enables the S-GW session idle timer.
dur_seconds
Specifies the time limit, in seconds, after which the S-GW session will be torn down. Valid entries are from 0
to 4294967295.
to 4294967295.
micro-checkpoint-periodicitytime_in_seconds
Specifies the micro-checkpoint periodicity for idlesecs, in seconds.
time_in_seconds
must be an integer from 10 to 10000 seconds.
Default: 10
Important:
The
micro-checkpoint-periodicity
value should be less than
idle timeout
value.
Usage
The S-GW session idle timer removes stale sessions in those cases where the session is removed on the other
nodes but due to some issue remains on the S-GW. Once configured, the session idle timer will tear down
nodes but due to some issue remains on the S-GW. Once configured, the session idle timer will tear down