Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
▀ dcca peer-select
▄ Command Line Interface Reference, StarOS Release 18
8824
dcca peer-select
Specifies the Diameter credit control primary and secondary peer for credit control.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
dcca peer-select peer host_name [ realm realm_name ] [ secondary-peer host_name [ realm
realm_name ] ]
realm_name ] ]
no dcca peer-select
no
Removes the previously configured Diameter credit control peer selection.
peer host_name
Specifies a unique name for the peer.
peer_name
must be an alphanumeric string of 1 through 63 characters
that allows punctuation marks.
secondary-peer host_name
Specifies a back-up host that is used for fail-over processing. When the route-table does not find an available
route, the secondary host performs a fail-over processing.
route, the secondary host performs a fail-over processing.
host_name
must be an alphanumeric string of 1
through 63 characters that allows punctuation marks.
realm realm_name
The
realm_name
must be an alphanumeric string of 1 through 63 characters that allows punctuation marks.
The realm may typically be a company or service name.
Usage
Use this command to select a Diameter credit control peer and realm.
Caution:
This configuration completely overrides all instances of
diameter peer-select
that have been
configured with in the Credit Control Configuration Mode for an Active Charging service.
Example
The following command selects a Diameter credit control peer named
test
and a realm of
companyx
: