Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
▀ ipv6 address
▄ Command Line Interface Reference, StarOS Release 18
8872
ipv6 address
Configures a static IP address for use by the subscriber.
Product
PDSN
GGSN
ASN-GW
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
[ no ] ipv6 address { prefix address | prefix-pool name }
no
Deletes a previously configured ipv6 address.
ipv6 address
address
Specifies an IPv6 address.
address
is entered using IPv6 colon-separated-hexadecimal notation.
prefix
Specifies a static IPv6 address.
prefix-pool
name
Specifies an IPv6 prefix pool name.
name
is an alphanumeric string of 1 through 31 characters.
Usage
Use this command to assign a static IPv6 address to the subscriber. This address will be used each time the
subscriber establishes data sessions.
subscriber establishes data sessions.
Example
The following command configures a static IP address of
2001:4A2B::1f3F
with a mask length of
24
to the
subscriber:
ipv6 address 2001:4A2B::1f3F/24