Cisco Cisco Packet Data Gateway (PDG)
Command Line Interface Reference, StarOS Release 18 ▄
8991
Chapter 316
Throttling Override Policy Configuration Mode Commands
This chapter describes the GTPC Throttling Override Policy Configuration Mode commands.
Throttling Override Policy mode allows an operator to configure the Throttling Override Policy that can be used at the
GGSN/P-GW nodes to selectively bypass throttling for a configured message type or for all messages in emergency call
or priority call or call for the configured APN.
GGSN/P-GW nodes to selectively bypass throttling for a configured message type or for all messages in emergency call
or priority call or call for the configured APN.
Important:
RLF Bypass Feature (enhancement to the GTP Throttling feature), used in the Throttling Override
Policy config mode, is a license-controlled feature. A valid feature license must be installed prior to configuring this
feature. Contact your Cisco account representative for more information.
feature. Contact your Cisco account representative for more information.
Mode
Exec > Global Configuration > Throttling Override Policy
configure > throttling-override-policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-throttling-override-policy)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).