Cisco Cisco ASR 5700
Global Configuration Mode Commands (T-threshold phspc)
threshold diameter diameter-retry-rate ▀
Command Line Interface Reference, StarOS Release 17 ▄
5601
threshold diameter diameter-retry-rate
Configures Diameter Retry Rate, alarm or alert thresholds based on the percentage of Diameter requests that were
retried during the polling interval.
retried during the polling interval.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold diameter diameter-retry-rate high_thresh [ clear low_thresh ]
default threshold diameter diameter-retry-rate
default
Configures this command with the default threshold settings.
Default: 0—disabled
Default: 0—disabled
high_thresh
Specifies the high threshold. If, within the polling interval, the percentage of Diameter requests retried equals
or exceeds
or exceeds
high_thresh
an alert or alarm is generated.
high_thresh
is an integer from 0 through 100.
Default: 0
clear low_thresh
Specifies the low threshold. If, within the polling interval, the percentage of Diameter requests retried falls
below
below
low_thresh
, a clear alarm is generated.
low_thresh
is an integer from 0 through 100.
Default: 0
Important:
This value is applicable for the Alarm mode, and ignored for the Alert mode. In addition, if this value
is not configured for the Alarm mode, the system assumes it is identical to the high threshold.
Usage
Diameter Retry Rate threshold generates alerts or alarms based on the percentage of Diameter requests that
were retried during the specified polling interval.
Alerts or alarms are triggered based on the following rules:
were retried during the specified polling interval.
Alerts or alarms are triggered based on the following rules:
Enter condition: Percentage of Diameter requests retried is greater than or equal to the high threshold.