Cisco Cisco ASR 5700
Global Configuration Mode Commands (T-threshold phspc)
threshold phsgw-auth-failure ▀
Command Line Interface Reference, StarOS Release 17 ▄
5681
threshold phsgw-auth-failure
Configures alarm or alert thresholds for the number of authentication failures in Personal Handyphone Service Gateway
(PHSGW) service.
(PHSGW) service.
Product
PHSGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold phsgw-auth-failure high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number for PHSGW authentication failures in any one PHSGW service. This
number must be met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number for PHSGW authentication failures in any one PHSGW service. This
number must be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of PHSGW authentication failures in any one PHSGW service. This
number must be met or exceeded to maintain a previously generated alarm condition. If the number of
subscribers falls beneath the low threshold within the polling interval, a clear alarm will be generated.
Specifies the low threshold number of PHSGW authentication failures in any one PHSGW service. This
number must be met or exceeded to maintain a previously generated alarm condition. If the number of
subscribers falls beneath the low threshold within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Set the monitoring and clearing thresholds for PHSGW authentication failures.
Alerts or alarms are triggered for authentication failures based on the following rules:
Alerts or alarms are triggered for authentication failures based on the following rules:
Enter condition: Actual number of PHSGW authentication failures in any one PHSGW service is
greater than or equal to the high threshold.
Clear condition: Actual number of PHSGW authentication failures in any one PHSGW service is less
than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.