Cisco Cisco ASR 5700
FA Service Configuration Mode Commands
▀ bind
▄ Command Line Interface Reference, StarOS Release 17
5006
bind
Binds the FA service to a logical IP interface serving as the Pi interface and specifies the maximum number of
subscribers that can access this service over the interface.
subscribers that can access this service over the interface.
Product
PDSN
ASN-GW
GGSN
PDIF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > FA Service Configuration
configure > context context_name > fa-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-fa-service)#
Syntax
bind address address [ max-subscribers count ]
no bind address
address
Specifies the IP address (address) of the interface configured as the Pi interface.
address
is specified in IPv4
dotted-decimal notation.
max-subscribers
max#
Default: 500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
count
can be configured to an integer from 0 through 500000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active packet processing cards installed in the system. Refer to the license key command for additional
information.
information.
Usage
Associate or tie the FA service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
characteristics of an Pi interface. Only one interface can be bound to a service. The interface should be
configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
max-subscribers
option, be sure to consider the following: