Cisco Cisco ASR 5700
Firewall-and-NAT Action Configuration Mode Commands
▀ flow check-point
▄ Command Line Interface Reference, StarOS Release 17
5046
flow check-point
This command checkpoints all the flows matching the Firewall-and NAT action.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Action Configuration
active-charging service service_name > fw-and-nat action action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-action)#
Syntax
flow check-point [ data-usage data_usage [ and | or ] | time-duration duration [ and | or
] ]
] ]
{ default | no } flow check-point
default
Configures the default Firewall action.
no
Deletes the Firewall action configuration.
data-usage data_usage
Specifies the data usage in bytes.
data_usage
must be an integer from 1 through 4294967295.
The maximum limit for data-usage is 4 GB.
time-duration duration
Specifies the time duration in seconds.
duration
must be an integer from 1 through 86400.
The maximum limit for time-duration is 24 hours.
and | or
This option allows to configure only
data-usage
or
time-duration
, or a combination of
data-usage
and
time-duration
.
Usage
Use this command to enable/disable the check-pointing of NATed flows and control the type of flows that
need to be check pointed based on specified criteria. Check pointing is done only for TCP and UDP flows.
need to be check pointed based on specified criteria. Check pointing is done only for TCP and UDP flows.