Cisco Cisco ASR 5700
ACS Rulebase Configuration Mode Commands
▀ rtsp initial-bytes-limit
▄ Command Line Interface Reference, StarOS Release 17
760
rtsp initial-bytes-limit
This command allows to set the maximum number of uplink and downlink bytes, added together to accumulate, while
rule matching and charging is being delayed for RTSP flows. The limit is per RTSP flow.
rule matching and charging is being delayed for RTSP flows. The limit is per RTSP flow.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
rtsp initial-bytes-limit rtsp_bytes
default rtsp initial-bytes-limit
default
Configures the RTSP initial packets limit to 6000 bytes.
RTSP_bytes
Specifies the maximum number of uplink and downlink bytes limit.
rtsp_bytes
must be an integer from 1 through 256000.
Usage
Use this command to configure the maximum number of uplink and downlink bytes per RTSP flow that can
be accumulated before the first SETUP request. The accumulated bytes include both TCP-control packets as
well as RTSP packets. Once this limit is reached, rule matching occurs and charging is enforced on the flow.
This command is used in conjunction with the
be accumulated before the first SETUP request. The accumulated bytes include both TCP-control packets as
well as RTSP packets. Once this limit is reached, rule matching occurs and charging is enforced on the flow.
This command is used in conjunction with the
flow rtsp-all-pkts charge-to-application
command.
Example
The following command sets the RTSP initial bytes limit to 9000 bytes:
rtsp initial-bytes-limit 9000