Cisco Cisco Packet Data Gateway (PDG)

Seite von 8994
APN Profile Configuration Mode   
▀  qos rate-limit direction 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
1542 
   
qos rate-limit direction 
Configures the actions governing the subscriber traffic flow, if the flow violates or exceeds the configured or netogiated 
peak or committed data-rates. 
This command can be entered multiple times to specify different combinations of traffic direction and class. The SGSN 
only performs traffic policing if 
qos rate-limit direction
 is configured. 
Additional information on the QoS traffic policing functionality is located in the System Administration Guide
Product
 
SGSN 
S-GW 
SAEGW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > APN Profile Configuration 
configure > apn-profile profile_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(apn-profile-profile_name)# 
Syntax
 
qos rate-limit direction { downlink | uplink } [ burst-size { auto-readjust [ duration 
seconds
 ] | bytes } ] [ class { background | conversational | interactive 
traffic_priority | streaming } ] [ exceed-action { drop | lower-ip-precedence | transmit 
} ] [ gbr-qci [ committed-auto-readjust durarion
 seconds ] ] [ non-gbr-qci [ committed-
auto-readjust durarion 
 seconds ] ] [ violate-action { drop | lower-ip-precedence | 
transmit } ] +
 
remove qos rate-limit direction { downlink | uplink } [ class { background | 
conversational | interactive 
traffic_priority | streaming } ] 
remove
 
Removes the qos rate-limit direction entries from the configuration. 
downlink | uplink
 
Apply the limits and actions configured with the other keywords to the selected link: 
downlink
 - This is the direction from the GGSN or P-GW to the MS.  
uplink
 - This is the direction from the MS to the GGSN or the P-GW. 
burst-size { auto-readjust [ duration
 
seconds ] | bytes }
 
Default: See the table of class default values in the Usage section below. 
This keyword specifies the peak burst size allowed. System measurements for this value exclude the GTP and 
outer packet headers. Supported options include: 
 
auto-readjust
: This keyword enables dynamic burst-size calculation using negotiated peak data-rate 
and negotiated committed data-rate.