Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands I-M
▀ ip rri
▄ Command Line Interface Reference, StarOS Release 17
2554
ip rri
Configures Reverse Route Injection (RRI) egress clear port IPv4 parameters. (VPC-VSM only)
Product
SecGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
ip rri { ip_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name
]
]
no ip rri { ip_address | next-hop nexthop_address } interface interface_name [ vrf
vrf_name ]
vrf_name ]
no
Disables the specified RRI egress parameters.
ip_address
Specified in IPv4 dotted-decimal notation.
next-hop
nexthop_address
Next hop address specified in IPv4 dotted-decimal notation. The next hop IP address is not required for point-
to-point and tunnel interfaces.
to-point and tunnel interfaces.
interface
interface_name
Specifies the name of an existing egress interface as an alphanumeric string of 1 through 79 characters.
vrf
vrf_name
Specifies the name of an existing VRF as an alphanumerical string of 1 through 63 characters.
Usage
Use this command to configure RRI regress clear port IPv4 parameters.
Example
ip rri 10.1.1.1 interface rri02