Cisco Cisco Packet Data Gateway (PDG)
Crypto Map IPSec IKEv1 Configuration Mode Commands
▀ set
▄ Command Line Interface Reference, StarOS Release 17
2964
set
Configures parameters for the dynamic crypto map.
Product
ePDG
FA
GGSN
HA
HeNBGW
HNBGW
HSGW
MME
P-GW
PDSN
S-GW
SAEGW
SCM
SecGW
SGSN
Privilege
Security Administrator
Mode
Exec > Global Configuration > Context Configuration > Crypto Map IPSec IKEv1 Configuration
configure > context context_name > crypto map policy_name ipsec-ikev1
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-crypto-map)#
Syntax
set { bgp
peer_address
| control-dont-fragment { clear-bit | copy-bit | set-bit }
| ikev1 natt [ keepalive
sec
] | ip mtu
bytes
| ipv6 mtu
bytes
| mode { aggressive |
main }
| peer
peer_address
| pfs { group1 | group2 | group5 } |
phase1-idtype { id-
key-id | ipv4-address [ mode { aggressive | main } ] |
phase2-idtype { ipv4-
address | ipv4-address-subnet } | security-association lifetime { disable-phase2-
rekey | keepalive | kilo-bytes
rekey | keepalive | kilo-bytes
kbytes
| seconds
secs
}
transform-set
transform_name
[
transform-set
transform_name2 ...
transform-set
transform_name6
]
no set { ikev1 natt | pfs | phase1-idtype |
phase2-idtype | security-association
lifetime { disable-phase2-rekey | keepalive | kilo-bytes | seconds } | transform-
set transform_name
set transform_name
[ transform-set
transform_name2 ...
transform-set
transform_name6
]