Cisco Cisco Packet Data Gateway (PDG)
DHCPv6 Client Configuration Mode Commands
server-dead-time ▀
Command Line Interface Reference, StarOS Release 17 ▄
3471
server-dead-time
Configures the amount of time that the client attempts to communicate with an unresponsive DHCPv6 server. DHCPv6
server is considered to be dead if it doesn't respond after given tries from client.
server is considered to be dead if it doesn't respond after given tries from client.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > DHCPv6 Service Configuration > DHCPv6 Client
Configuration
Configuration
configure > context context_name > dhcpv6-service service_name > dhcpv6-client
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-dhcpv6-client)#
Syntax
server-dead-time dead_time
default server-dead-time
default
Returns the command to its default setting of 5.
dead_time
Specifies the maximum amount of time (in seconds) that the client attempts to communicate with an
unresponsive DHCPv6 server.
unresponsive DHCPv6 server.
dead_time
must be an integer value from 1 through 1932100.
Default: 5
Usage
Use this command to specify the maximum amount of time (in seconds) that the client attempts to
communicate with an unresponsive DHCPv6 server.
This command works in conjunction with the
communicate with an unresponsive DHCPv6 server.
This command works in conjunction with the
max-retransmissions
command to set a limit to the
number of times that the system attempts to communicate with an unresponsive DHCPv6 server before it is
considered a failure.
considered a failure.
Example
The following command configures the client to continue trying to communicate with an unresponsive
DHCPv6 server for no more than
DHCPv6 server for no more than
10
seconds:
server-dead-time 10