Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (T-threshold phspc)
▀ task facility ipsecmgr
▄ Command Line Interface Reference, StarOS Release 17
5518
task facility ipsecmgr
Configures IPSec manager settings.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
task facility ipsecmgr { ikev1 { task-count { increased | normal } } | task-count {
increased | normal } }
increased | normal } }
ikev1 { task-count { increased | normal } }
Default:
normal
Adjusts the IPSec manager task count to support EHA for IKEv1. See
task-count
below.
task-count { increased | normal }
Default:
normal
Adjusts the IPSec manager task count to support EHA.
increased
: Starts additional IPSec manager tasks operating on the packet processing cards. In increased
mode, they run on all but demux packet processing cards. Also, all the IPSec managers start at the same time
when an active non-demux card is detected and IPSec is configured.
when an active non-demux card is detected and IPSec is configured.
normal
: Uses the standard algorithm for allocating memory for IPSec manager tasks. In normal mode, IPSec
managers do not run on session packet processing cards.
Caution:
If
task-count
is set to
normal
and session recovery is enabled, IPSec manager tasks are not
allowed to start on most packet processing cards. Because the resources are not reserved, IPSec managers in normal
mode only run on demux packet processing cards.
mode only run on demux packet processing cards.
Usage
Sets IPSec manager parameters for all IPSec managers in the system.
Example
Use the following command to set the IPSec manager task count to
increased
mode:
task facility ipsecmgr task-count increased