Cisco Cisco Packet Data Gateway (PDG)
Gs Service Configuration Mode Commands
▀ max-retransmission
▄ Command Line Interface Reference, StarOS Release 17
6022
max-retransmission
This command configures the retransmission values for different procedure counters in Gs service as described in TS
29.018.
29.018.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Gs Service Configuration
configure > context context_name > gs-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-gs-service)#
Syntax
max-retransmissions { n8 | n9 | n10 | n12 } retrans_num
default max-retransmissions { n8 | n9 | n10 | n12 }
no
Removes the configured Gs procedures from this Gs service.
{ n8 | n9 | n10 | n12 }
Specifies the various Gs service procedures that are available to be used to communicate with VLR(s).
n8: Defines the maximum number of retries for explicit IMSI detach from a non-GPRS service. Default
is 2.
n9
: Defines the maximum number of retries for explicit IMSI detach from a non-GPRS service. Default
is 2.
n10
: Defines the maximum number of retries for implicit IMSI detach from the GPRS service. Default
is 2.
n12
: Defines the maximum number of retries for BSSAP+ to send Reset Indication messages. Default
is 2.
retrans_num
Default: 2
Specifies the number of re-transmission of message for specified procedures.
Specifies the number of re-transmission of message for specified procedures.
retrans_num
: Must be an integer from 0 through 10.
Usage
Use this command to configure the retransmission values for specific procedure counters in Gs service.
counters are based on TS 29.018.
This command can be entered for each procedure counter separately.
counters are based on TS 29.018.
This command can be entered for each procedure counter separately.