Cisco Cisco Packet Data Gateway (PDG)
GTP-U Service Configuration Mode Commands
▀ ipsec-allow-error-ind-in-clear
▄ Command Line Interface Reference, StarOS Release 17
6134
ipsec-allow-error-ind-in-clear
Configures whether error-indication is dropped or sent without IPSec tunnel.
Product
S-GW
SAEGW
SGSN
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > GTP-U Service Configuration
configure > context context_name > gtpu-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-gtpu-service)#
Syntax
[ default | no ] ipsec-allow-error-ind-in-clear
default
Error-indication is dropped if no IPSec tunnel is present for that peer.
no
Disables the feature.
Usage
Use this command to determine whether error-indication is dropped or sent without an IPSec tunnel.
On receiving data packets for a session that does not exist, error-indication needs to be sent back to the peer.
If there is no IPSec tunnel present with that peer, error-indication may be either dropped or sent without any
IPSec tunnel.
On receiving data packets for a session that does not exist, error-indication needs to be sent back to the peer.
If there is no IPSec tunnel present with that peer, error-indication may be either dropped or sent without any
IPSec tunnel.
Example
The following command allows error-indication to be sent without any IPSec tunnel:
ipsec-allow-error-ind-in-clear