Cisco Cisco Packet Data Gateway (PDG)
HSGW Service Configuration Mode Commands
▀ retransmission-timeout
▄ Command Line Interface Reference, StarOS Release 17
6284
retransmission-timeout
Configures the maximum allowable time for the HSGW service to wait for a response from the eAN/PCF before it
attempts to communicate with the eAN/PCF again (if the system is configured to retry the PCF), or marks the eAN/PCF
as unreachable.
attempts to communicate with the eAN/PCF again (if the system is configured to retry the PCF), or marks the eAN/PCF
as unreachable.
Product
HSGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-hsgw-service)#
Syntax
retransmission-timeout time
[ default | no ] retransmission-timeout
default
Resets the timeout setting to the default value of 3.
no
Deletes a previously configured timeout value.
time
Specifies the maximum allowable time (in seconds) for the HSGW service to wait for a response from the
eAN/PCF before it: a) attempts to communicate with the eAN/PCF again (if the system is configured to retry
the PCF), or b) marks the eAN/PCF as unreachable.
eAN/PCF before it: a) attempts to communicate with the eAN/PCF again (if the system is configured to retry
the PCF), or b) marks the eAN/PCF as unreachable.
time
is an integer from 1 through 1000000. Default: 3
Usage
Use the retransmission timeout command in conjunction with the
max-retransmissions
command in
order to configure the HSGW service’s behavior when it does not receive a response from a particular PCF.
Example
The following command configures a retransmission timeout value of
5
seconds:
retransmission-timeout 5