Cisco Cisco Packet Data Gateway (PDG)
Command Line Interface Reference, StarOS Release 17 ▄
6963
Chapter 200
Loopback Interface Configuration Mode Commands
The Loopback Interface Configuration Mode is used to create and manage an internal IP network address. The address
must be configured with a 32-bit mask.
must be configured with a 32-bit mask.
Mode
Exec > Global Configuration > Context Configuration > Ethernet Interface Configuration
configure > context context_name > interface interface_name loopback
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-loopback)#
Important:
Available commands or keywords/variables vary based on platform type, product version, and
installed license(s).