Cisco Cisco Packet Data Gateway (PDG)
MAG Service Configuration Mode Commands
▀ bind
▄ Command Line Interface Reference, StarOS Release 17
7110
bind
Binds the service to a logical IP interface serving as the S2a (HSGW) or S5/S8 (S-GW) interface and specifies the
maximum number of subscribers that can access this service over the configured interface.
maximum number of subscribers that can access this service over the configured interface.
Product
HSGW
S-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MAG Service Configuration
configure > context context_name > mag-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mag-service)#
Syntax
bind { address ipv6_address | ipv4-address ipv4_address } [ max-subscribers num ]
no bind address
no
Removes the interface binding from this service.
address ipv6_address
Specifies the IPv6 address of the interface configured as the S5/S8 interface.
ipv6_address
is specified in IPv6 colon-separated-hexadecimal notation.
ipv4-address ipv4_address
Specifies the IPv4 address of the interface configured as the S2a or S5/S8 interface.
ipv4_address
is specified in IPv4 colon-separated-hexadecimal notation.
max-subscribers num
Default: 1500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
num
must be an integer from 0 through 3000000.
Important:
The maximum number of subscribers supported depends on the installed license
key and the number of active packet processing cards in the system. A fully loaded system can
support 3,000,000 total subscribers. Refer to the
support 3,000,000 total subscribers. Refer to the
license key
command and the Usage section
(below) for additional information.