Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Mode Commands
▀ nas gmm-qos-ie-mapping
▄ Command Line Interface Reference, StarOS Release 17
7264
nas gmm-qos-ie-mapping
Configures which QOS the MME uses in NAS GMM QoS IE and GTPv1 Context response message when the
subscriber comes to MME via a handover from a GN/GP SGSN.
subscriber comes to MME via a handover from a GN/GP SGSN.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
nas gmm-qos-ie-mapping { gngp-imported-qos | native-eps-qos }
gngp-imported-qos
Configures the MME to send the QoS received from GN/GP SGSN (whenever applicable).
native-eps-qos
Configures the MME to send the EPS (4G) QoS received from HSS.
This is the default setting.
This is the default setting.
Usage
When a subscriber comes to MME via a handover from Gn/Gp SGSN, this command controls whether the
MME is to use the QoS received from the SGSN, or whether to use the updated EPS QoS received from the
HSS. This value is then mapped to gmm-qos-ie in subsequent NAS messages and in GTPv1 Context response
messages.
MME is to use the QoS received from the SGSN, or whether to use the updated EPS QoS received from the
HSS. This value is then mapped to gmm-qos-ie in subsequent NAS messages and in GTPv1 Context response
messages.
Example
The following command configures the MME to use the QoS values from the Gn/Gp SGSN in gmm-qos-ie
NAS messages and GTPv1 Context response messages.
NAS messages and GTPv1 Context response messages.
nas gmm-qos-ie-mapping gngp-imported-qos