Cisco Cisco Packet Data Gateway (PDG)
MPLS-IP Configuration Mode Commands
▀ protocol ldp
▄ Command Line Interface Reference, StarOS Release 17
7330
protocol ldp
Creates or removes the MPLS label distribution protocol (LDP) configuration, or configures an existing protocol and
enters the MPLS-LDP Configuration Mode in the current context. This command configures the protocol parameters for
MPLS LDP.
enters the MPLS-LDP Configuration Mode in the current context. This command configures the protocol parameters for
MPLS LDP.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MPLS-IP Configuration
configure > context context_name > mpls-ip
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mpls)#
Syntax
[ no ] protocol ldp
no
Removes the configured MPLS-LDP mode from MPLS-IP Configuration mode.
Usage
Use this command to create/ or remove the MPLS LDP configuration, or configure an existing protocol. If
required mode already exists it enters the MPLS-LDP Configuration Mode in the current context.
Entering this command results in the following prompt:
required mode already exists it enters the MPLS-LDP Configuration Mode in the current context.
Entering this command results in the following prompt:
[context_name]hostname(config-ldp)#
The commands configured in this mode are defined in the MPLS-LDP Configuration Mode Commands
chapter.
chapter.
Example
The following command creates and enters the MPLS-LDP Protocol mode:
protocol ldp