Cisco Cisco Packet Data Gateway (PDG)
PCC-TimeDef Configuration Mode Commands
▀ start time
▄ Command Line Interface Reference, StarOS Release 17
7758
start time
This command defines PCC-TimeDefs with a start and end time of a day for an event to trigger a procedure or condition
in an IP-CAN session.
in an IP-CAN session.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC TimeDef Configuration
configure > context context_name > pcc-service service_name > timedef timedef_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-timedef)#
Syntax
[no] start time start_time end time end_time
no
Removes the specified time definition.
time
start_time
Specifies the start time
start_time
in
HH
MIN
SS
format.
Following format is used for
HH
MIN
SS
in
start_time
:
HH
specifies the hour of the day in 24 hour format and must be an integer between 00 through 23.
MIN
specifies the minutes of the hour of the day must be an integer between 00 through 59.
SS
specifies the seconds of the minute of the day must be an integer between 00 through 59.
end
time
end_time
Specifies the end time
end_time
in
HH
MIN
SS
format.
Following format is used for
HH
MIN
SS
in
end_time
:
HH
specifies the end hour of the day in 24 hour format and must be an integer between 00 through 23.
MIN
specifies the minutes of the end hour of the day must be an integer between 00 through 59.
SS
specifies the seconds of the minute of the end hour must be an integer between 00 through 59.
Usage
Use this command to define a PCC-TimeDef with a start and end time for an event to trigger a procedure or
condition in an IP-CAN session.
condition in an IP-CAN session.
Example
The following command defines a PCC-TimeDef with start at 00 Hrs. 30 mins. and 00 seconds and end at 23
Hrs. 59 mins. and 59 seconds:
Hrs. 59 mins. and 59 seconds: