Cisco Cisco Packet Data Gateway (PDG)
RNC Configuration Mode Commands
ran-information-management ▀
Command Line Interface Reference, StarOS Release 17 ▄
8167
ran-information-management
Use this command to inform the SGSN which RNC are capable of handling RAN information management (RIM)
messages.
messages.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > luPS Service Configuration > RNC Configuration
configure > context context_name > iups-service service_name > rnc id rnc_id
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service-rnc)#
Syntax
[ default | no ] ran-information-management
default
Resets the default so RIM is disabled.
no
Disables the RIM support in the configuration file.
Usage
By default, handling of RAN information management (RIM) messages is disabled. This command informs
the SGSN which RNC are capable of handling RIM messages. This configuration only becomes ‘operational’
if the
the SGSN which RNC are capable of handling RIM messages. This configuration only becomes ‘operational’
if the
ran-information-management
command is enabled in the SGSN global configuration mode.
When RIM support is enabled on both the SGSN and the destination node, then all RIM PDUs are forwarded
to the BSC/RNC. If RIM message handling is not enabled on both nodes, then the RIM PDUs are dropped
silently.
to the BSC/RNC. If RIM message handling is not enabled on both nodes, then the RIM PDUs are dropped
silently.
Example
Use the following command to enable RIM support:
ran-information-management
Use the following command to disable RIM support that has been added to the configuration:
no ran-information-management