Cisco Cisco Packet Data Gateway (PDG)

Route-map Configuration Mode Commands

set origin ▀

Command Line Interface Reference, StarOS Release 17 ▄

8263

set origin

Sets the Border Gateway Protocol (BGP) origin code to a specified value. This command is for route maps that are used
with BGP routing only.

Product

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Context Configuration > Route-map Configuration

configure > context context_name > route-map map_name { deny | permit }

seq_number

Entering the above command sequence results in the following prompt:

[context_name]host_name(config-route-map)#

Syntax

[ no ] set origin { egp | igp | incomplete }

Disables setting the origin code.

egp

Sets the origin code to specify that the path is from a remote External Gateway Protocol (EGP) system.

igp

Sets the origin code to specify that the path is from a local Interior Gateway Protocol (IGP) system.

incomplete

Sets the origin code to specify that the path is from an unknown system.

Usage

Use this command to set a specified origin code for BGP.

Example

To set the origin code to be from an External Gateway Protocol (EGP) system, enter the following command:

set origin egp