Cisco Cisco Packet Data Gateway (PDG)
S-GW Service Configuration Mode Commands
ntsr session-hold timeout ▀
Command Line Interface Reference, StarOS Release 17 ▄
8621
ntsr session-hold timeout
Configures a timer to hold the session after path failure is detected at the MME (for Network Triggered Service
Restoration).
Restoration).
Product
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
[ no ] ntsr session-hold timeout seconds
no
Disables the NTSR session-hold timeout.
ntsr session-hold timeout
seconds
Configures the timer duration, in seconds, that determines how long the session will be held after path failure
is detected during MME restoration. Valid entries are from 1 to 3600 seconds.
is detected during MME restoration. Valid entries are from 1 to 3600 seconds.
Usage
Use this command to configure the timer duration, in seconds, that determines how long the session will be
held after path failure is detected during MME restoration.
held after path failure is detected during MME restoration.
Example
To configure the ntsr session-hold timeout for 10 seconds.
ntsr session-hold timeout 10