Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
bandwidth default-policy ▀
Command Line Interface Reference, StarOS Release 17 ▄
647
bandwidth default-policy
This command allows you to configure the default bandwidth policy for the current rulebase.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
bandwidth default-policy bandwidth_policy_name [ fallback-enabled ]
no bandwidth default-policy
no
If previously configured, deletes the bandwidth default-policy configuration from the current rulebase.
bandwidth_policy_name
Specifies the default bandwidth policy for the current rulebase.
bandwidth_policy_name
must be the name of a bandwidth policy, and must be an alphanumeric string of
1 through 63 characters.
fallback-enabled
Determines whether policy under rulebase can be applied as a fallback value. Fallback is disabled by default.
Usage
Use this command to configure the default bandwidth policy for a rulebase.
For subscribers using the current rulebase, the default bandwidth policy will be used if in the APN/subscriber
profile the
For subscribers using the current rulebase, the default bandwidth policy will be used if in the APN/subscriber
profile the
default active-charging bandwidth-policy fallback-enabled
command is
configured, or no bandwidth policy is configured.
Example
The following command configures a bandwidth policy named
standard
for the rulebase:
bandwidth default-policy standard