Cisco Cisco Packet Data Gateway (PDG)
APN Configuration Mode Commands
timeout long-duration ▀
Command Line Interface Reference, StarOS Release 16 ▄
1429
timeout long-duration
Configures the long duration timeout and inactivity duration for subscriber sessions.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
timeout long-duration ldt_timeout [ inactivity-time inact_timeout ]
no timeout long-duration
no
Indicates the timeout specified is to be returned to its default behavior. If no specific timeout is specified then
all timeouts are set to their default behavior.
all timeouts are set to their default behavior.
ldt_timeout
Default: 0
Designates the maximum duration of the session (in seconds) before the system automatically
reports/terminates the session.
Specifies the maximum amount of time (in seconds) before the specified timeout action is initiated.
Designates the maximum duration of the session (in seconds) before the system automatically
reports/terminates the session.
Specifies the maximum amount of time (in seconds) before the specified timeout action is initiated.
ldt_timeout
must be an integer value in the range from 0 through 4294967295.
The special value 0 disables the timeout specified.
inactivity-time
inact_timeout
Specifies the maximum amount of time (in seconds) before the specified session is marked as dormant.
inact_timeout
must be an integer value in the range from 0 through 4294967295.
The special value 0 disables the inactivity time specified.
Usage
Use this command to set the long duration timeout period and inactivity timer for subscriber sessions. Reduce
the idle timeout to free session resources faster for use by new requests.
Refer to the
the idle timeout to free session resources faster for use by new requests.
Refer to the
long-duration-action detection
and
long-duration-action disconnection
commands in this chapter for additional information.
Example
The following command sets the long duration timeout duration to
300
seconds and the inactivity timer for
subscriber session to
45
seconds.