Cisco Cisco Packet Data Gateway (PDG)
APN Profile Configuration Mode
timeout bearer-inactivity ▀
Command Line Interface Reference, StarOS Release 16 ▄
1517
timeout bearer-inactivity
Supports a bearer inactivity timeout for GBR and non-GBR S-GW bearer type sessions.
Product
S-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-profile-profile_name)#
Syntax
[ remove ] timeout bearer-inactivity [ gbr | non-gbr ] dur_seconds volume-threshold
{ total bytes | uplink bytes | downlink bytes} | exclude-default-bearer
{ total bytes | uplink bytes | downlink bytes} | exclude-default-bearer
remove
Removes the timeout bearer-inactivity setting.
timeout
Specifies that a session time out value will be configured for this APN profile.
bearer-inactivity
Specifies that a session time out value will be configured for this APN profile.
gbrdur_seconds
Specifies that the system will check for low activity on a GBR bearer.
dur_seconds
specifies the bearer
inactivity timer in seconds. Valid entries are from 900 to 2592000 seconds (15 minutes to 720 hours).
non-gbrdur_seconds
Specifies that the system will check for low activity on a non-GBR bearer.
dur_seconds
specifies the bearer
inactivity timer in seconds. Valid entries are from 900 to 2592000 seconds (15 minutes to 720 hours).
volume-threshold
Specifies that a threshold value of the data traffic for a bearer will be used for the inactivity timeout value.
totalbytes
Specifies that the total of both uplink and downlink data will be used as a volume threshold.
bytes
must be a
value from 1 to 4294967295.