Cisco Cisco Packet Data Gateway (PDG)
Bulk Statistics Configuration Mode Commands
▀ transfer-interval
▄ Command Line Interface Reference, StarOS Release 16
1834
transfer-interval
Configures the frequency of transfer of collected statistics to the receiver.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Bulk Statistics Configuration
configure > bulkstats mode
Entering the above command sequence results in the following prompt:
[local]host_name(config-bulkstats)#
Syntax
transfer-interval minutes
minutes
Specifies the number of minutes between the transfer of collected statistics to the receivers as an integer from
1 through 999999.
1 through 999999.
Usage
Modify the transfer interval based upon the number of sessions per second. As the number of session requests
a second increases it may become necessary to increase the transfer interval to reduce the processing
overhead frequency for statistics delivery. This is tempered by the impact reduced resolution of statical data
has on usefulness of data when the interval gets larger than the least busy hours and most busy hours of the
day.
The system is shipped from the factory with the transfer interval set to 480 minutes.
a second increases it may become necessary to increase the transfer interval to reduce the processing
overhead frequency for statistics delivery. This is tempered by the impact reduced resolution of statical data
has on usefulness of data when the interval gets larger than the least busy hours and most busy hours of the
day.
The system is shipped from the factory with the transfer interval set to 480 minutes.
Example
transfer-interval 1440