Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands I-M
mpls bgp forwarding ▀
Command Line Interface Reference, StarOS Release 16 ▄
2551
mpls bgp forwarding
Globally enables Multi protocol Label Switching (MPLS) Border Gateway Protocol (BGP) forwarding.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] mpls bgp forwarding
no
Disables MPLS BGP forwarding.
Usage
Use this command to globally enable the MPLS BGP forwarding. By enabling this command, the BGP
VPNv4 routes need not have an underlying LSP to forward the IP packets. If this command is not enabled,
then the nexthop for the BGP routes must be reachable via LDP.
VPNv4 routes need not have an underlying LSP to forward the IP packets. If this command is not enabled,
then the nexthop for the BGP routes must be reachable via LDP.
Caution:
This command should always be enabled when nexhtop is not reachable thorough LSP.
Example
The following command enables the MPLS BGP forwarding on the system:
mpls bgp forwarding