Cisco Cisco Packet Data Gateway (PDG)
Credit Control Configuration Mode Commands
▀ diameter pending-timeout
▄ Command Line Interface Reference, StarOS Release 16
2742
diameter pending-timeout
This command configures the maximum time period to wait for response from a Diameter peer.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Credit Control Configuration
active-charging service service_name > credit-control
Entering the above command sequence results in the following prompt:
[local]host_name(config-dcca)#
Syntax
diameter pending-timeout duration deciseconds msg-type { any | ccr-event | ccr-initial |
ccr-terminate | ccr-update }
ccr-terminate | ccr-update }
default diameter pending-timeout
default
Disables DCCA resending message at pending-timeout.
duration
Specifies the timeout duration (in deciseconds). The value must be an integer from 1 through 3000.
deciseconds msg-type { any | ccr-event | ccr-initial | ccr-terminate | ccr-update
}
}
Specifies independent timers (in deciseconds) for all message types like CCR-I, CCR-U, CCR-T and CCR-E.
The default time will be 100 deciseconds (10 seconds).
This keyword option provides additional flexibility for operator to configure independent timers with reduced
granularity.
This feature implementation ensures that the timer configuration is backward compatible. If the CLI
command is configured without “
The default time will be 100 deciseconds (10 seconds).
This keyword option provides additional flexibility for operator to configure independent timers with reduced
granularity.
This feature implementation ensures that the timer configuration is backward compatible. If the CLI
command is configured without “
desiseconds
” and “
msg-type
”, the configured time will be taken as
seconds and while displaying the CLI it will be converted to deciseconds and msg-type will be “
any
”.
after-expiry-try-secondary-host
This keyword is deprecated. This can now be managed using the
retry-after-tx-expiry
and
go-
offline-after-tx-expiry
keywords in the
Usage
Use this command to set the maximum time for Diameter credit control to receive a response from its peer.