Cisco Cisco Packet Data Gateway (PDG)
Crypto Template Configuration Mode Commands
whitelist ▀
Command Line Interface Reference, StarOS Release 16 ▄
2935
whitelist
Enables the use of an existing whitelist (access permitted) file by a security gateway.
Product
All products supporting IPSec whitelisting
Important:
This command appears in the CLI for this release. However, it has not been qualified for use with
any current Cisco StarOS gateway products.
Privilege
Security Administrator
Syntax
whitelist
no whitelist
no
Disables the use of a whitelist.
Usage
Enable the use of a previously created whitelist to allow privileged peers access via a security gateway.
A whitelist is a list or register of entities that are being provided a particular privilege, service, mobility,
access or recognition. With whitelisting, no peer is allowed to connect unless it appears in the list.
Each entry in the whitelist file should contain the ID type so that the validation is performed for that ID type.
In every entry, the ID type and ID value should be separated by a space. Only DOS and UNIX file formatting
are supported. For additional information, refer to the System Administration Guide.
A whitelist is a list or register of entities that are being provided a particular privilege, service, mobility,
access or recognition. With whitelisting, no peer is allowed to connect unless it appears in the list.
Each entry in the whitelist file should contain the ID type so that the validation is performed for that ID type.
In every entry, the ID type and ID value should be separated by a space. Only DOS and UNIX file formatting
are supported. For additional information, refer to the System Administration Guide.
Example
whitelist