Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Commands (D-S)
diameter disable endpoint ▀
Command Line Interface Reference, StarOS Release 16 ▄
3957
diameter disable endpoint
Disables a Diameter endpoint without removing the peer’s configuration.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
diameter disable endpoint endpoint_name peer peer_id
endpoint_name
Specifies the endpoint in which the peer is configured as an alphanumeric string of 1 through 63 characters.
peer
peer_id
Specifies the Diameter peer host name to be disabled as an alphanumeric string of 1 through 63 characters.
Usage
Use this command to administratively disable a Diameter peer without removing the peer configuration. This
command will tear down all connections on the specified peer (by sending a DPR if the configuration
demands the same at peer level configuration). The peer will remain in disabled state until it is enabled again.
Also see the
command will tear down all connections on the specified peer (by sending a DPR if the configuration
demands the same at peer level configuration). The peer will remain in disabled state until it is enabled again.
Also see the
diameter enable endpoint
command.
Example
This command disables the Diameter peer
peer12
:
diameter disable endpoint endpoint1 peer peer12