Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (L-S)
ntsr pool-id ▀
Command Line Interface Reference, StarOS Release 16 ▄
5333
ntsr pool-id
Configures a pool ID and pool type (either MME or S4-SGSN) for Network Triggered Service Restoration (NTSR).
Once executed, the user is placed in NTSR Pool Configuration Mode.
Once executed, the user is placed in NTSR Pool Configuration Mode.
Product
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
ntsr pool-id number pool-type [ mme | s4-sgsn ]
no ntsr pool-id
ntsr pool-idnumber
Specifies an ID number for this NTSR pool. Valid entries are from 1 to 65535.
pool-type
Specifies the type of pool for the pool-id. Options are MME or S4-SGSN.
Usage
This command is used to configure a pool ID and pool type (either MME or S4-SGSN) for NTSR. Once
executed, the operator must configure a peer IP address in NTSR Pool Configuration mode using the
executed, the operator must configure a peer IP address in NTSR Pool Configuration mode using the
peer-
ip-address
command.
Example
This example configures an NTSR pool ID of 1 and a pool type of mme.
ntsr pool-id 1 pool-type mme