Cisco Cisco Packet Data Gateway (PDG)
GTP-U Service Configuration Mode Commands
ipsec-tunnel-idle-timeout ▀
Command Line Interface Reference, StarOS Release 16 ▄
6041
ipsec-tunnel-idle-timeout
Configures the IPSec tunnel idle timeout after which IPSec tunnel deletion is triggered.
Product
S-GW
SAEGW
SGSN
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > GTP-U Service Configuration
configure > context context_name > gtpu-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-gtpu-service)#
Syntax
ipsec-tunnel-idle-timeout seconds
default ipsec-tunnel-idle-timeout
seconds
Default: 60
Specifies the number of seconds an IPSec tunnel is idle before tunnel deletion is triggered.
Specifies the number of seconds an IPSec tunnel is idle before tunnel deletion is triggered.
seconds
must be
an integer from 10 through 600.
default
Returns the command to its default setting of 60.
Usage
When there are no bearers on a particular IPSec tunnel, GTPUMGR initiates the delete for that tunnel. This
timer helps to avoid unnecessary IPSec tunnel deletions for an idle tunnel.
timer helps to avoid unnecessary IPSec tunnel deletions for an idle tunnel.
Example
The following command sets the IPsec tunnel idle timeout to
100
seconds:
ipsec-tunnel-idle-timeout 100