Cisco Cisco Packet Data Gateway (PDG)

 

▄  Command Line Interface Reference, StarOS Release 16 

Configures Generic Routing Encapsulation (GRE) parameters for the A10 protocol within the HSGW service. 

 

HSGW 

 

Administrator 

 

Exec > Global Configuration > Context Configuration > HSGW Service Configuration 

configure > context context_name > hsgw-service service_name

 

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-hsgw-service)# 

 

gre { checksum | checksum-verify | flow control [ action { disconnect-session | resume-
session } ] [ timeout msecs ] + | ip-header-dscp value { all-control-packets | setup-
packets-only } | reorder-timeout msecs | segmentation | sequence-mode { none | reorder } 
| sequence-numbers | threegppp2-ext-headers qos-marking } 

default gre { checksum | checksum-verify | flow-control | ip-header-dscp | reorder-
timeout | sequence-mode | sequence-numbers | threegppp2-ext-headers qos-marking } 

no gre { checksum | checksum-verify | flow-control | ip-header-dscp | segmentation | 
sequence-numbers | threegppp2-ext-headers qos-marking } 

 

Restores the specified parameter to its default setting. 

 

Disables the specified functionality. 

 

Enables the introduction of the checksum field in outgoing GRE packets. Default: disabled 

 

Enables verification of the GRE checksum (if present) in incoming GRE packets. Default: disabled 

flow-control [ action { disconnect-session | resume-session } ] [ timeout msecs

+ 

Default: no GRE flow-control 
Enables 3GPP2 GRE flow control which causes the HSGW to send flow control enabled Normal Vendor 
Specific Extensions (NVSE) in A11 RRPs. 

: 

Default: disconnect-session