Cisco Cisco Packet Data Gateway (PDG)
HSGW Service Configuration Mode Commands
ue-initiated-qos ▀
Command Line Interface Reference, StarOS Release 16 ▄
6195
ue-initiated-qos
Configures the HSGW behavior for UE initiated QoS requests.
Product
HSGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-hsgw-service)#
Syntax
[ default | no ] ue-initiated-qos
default
Returns the HSGW to the default behavior, where UE initiated QoS requests are accepted and forwarded to
the PCRF via Gxa interface.
the PCRF via Gxa interface.
no
Enables rejection of UE initiated QoS request for dedicated bearer in HSGW service. HSGW does not
forward the request to the PCRF over Gxa and instead rejects the UE initiated QoS immediately.
forward the request to the PCRF over Gxa and instead rejects the UE initiated QoS immediately.
Usage
Use this command to enable or disable support for UE initiated QoS functionality.
By default, UE initiated QoS requests are accepted and forwarded to the PCRF via Gxa interface. If PCRF
rejects the UE initiated QoS, UE request is rejected.
This command allows rejection of UE initiated QoS request for dedicated bearer in HSGW service. HSGW
does not forward the request to the PCRF over Gxa and instead rejects the UE initiated QoS immediately.
By default, UE initiated QoS requests are accepted and forwarded to the PCRF via Gxa interface. If PCRF
rejects the UE initiated QoS, UE request is rejected.
This command allows rejection of UE initiated QoS request for dedicated bearer in HSGW service. HSGW
does not forward the request to the PCRF over Gxa and instead rejects the UE initiated QoS immediately.
Example
The following command rejects UE-initiated QoS request for dedicated bearer in HSGW service:
no ue-initiated-qos