Cisco Cisco Packet Data Gateway (PDG)

IPv6 ACL Configuration Mode Commands

▀ redirect css service (for downlink, by TCP/UDP packets)

▄ Command Line Interface Reference, StarOS Release 16

6572

redirect css service (for downlink, by TCP/UDP packets)

Used to redirect subscriber sessions to a charging service based on the transmission control protocol/user datagram
protocol packets in the downlink (from the Mobile Node) direction.

Product

All

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Context Configuration > IPv6 ACL Configuration

configure > context context_name > ipv6 access-list ipv6_acl_name

Entering the above command sequence results in the following prompt:

[context_name]host_name(config-ipv6-acl)#

Syntax

redirect css service svc_name [ log ] downlink { tcp | udp } { { source_address
source_wildcard | any | host source_host_address } [ eq source_port | gt source_port | lt
source_port | neq source_port | range start_source_port end_source_port ] } { {
dest_address dest_wildcard | any | host dest_host_address } [ eq dest_port | gt dest_port
| lt dest_port | neq dest_port | range start_dest_port end_dest_port ] }

after redirect css service svc_name [ log ] downlink { tcp | udp } { { source_address
source_wildcard | any | host source_host_address } [ eq source_port | gt source_port | lt
source_port | neq source_port | range start_source_port end_source_port ] } { {
dest_address dest_wildcard | any | host dest_host_address } [ eq dest_port | gt dest_port
| lt dest_port | neq dest_port | range start_dest_port end_dest_port ] }

no redirect css service svc_name [ log ] downlink { tcp | udp } { { source_address
source_wildcard | any | host source_host_address } [ eq source_port | gt source_port | lt
source_port | neq source_port | range start_source_port end_source_port ] } { {
dest_address dest_wildcard | any | host dest_host_address } [ eq dest_port | gt dest_port
| lt dest_port | neq dest_port | range start_dest_port end_dest_port ] }

after

Indicates all rule definitions subsequent to this command are to be inserted after the command identified by
the exact options listed.
This moves the insertion point to be immediately after the rule definition which matches the exact options
specified such that new rule definitions will be added, in order, after the matching rule definition.