Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Mode Commands
bind s1-mme ▀
Command Line Interface Reference, StarOS Release 16 ▄
7067
Usage
Use this command to associate the MME service with a specific logical IP address that will be used for
binding the SCTP socket that communicates with the eNodeB using S1AP. Only one IP address can be
configured with this command for one MME service.
The MME passes the IP address during setting up the SCTP association with the eNodeB.
binding the SCTP socket that communicates with the eNodeB using S1AP. Only one IP address can be
configured with this command for one MME service.
The MME passes the IP address during setting up the SCTP association with the eNodeB.
Caution:
This is a critical configuration. The MME service can not be started without this configuration. Any
change to this configuration will cause the MME service to be restarted. Removing or disabling this configuration will
stop the MME service.
stop the MME service.
Important:
Up to two IPv4 or IPv6 addresses can be configured to support SCTP multi-homing.
Example
The following command would bind the logical IP interface with the address of
192.168.3.1
to the MME
service to interact with eNodeB:
bind s1-mme ipv4-address 192.168.3.1
The following command disables a binding that was previously configured:
no bind s1-mme ipv4address