Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Mode Commands
policy idle-mode ▀
Command Line Interface Reference, StarOS Release 16 ▄
7151
policy idle-mode
Configures the user-defined policies of session management for an LTE subscriber in an MME service.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
policy idle-mode detach { explicit | implicit }
[ default ] policy idle-mode detach
default
Sets the policy of idle mode detach for a subscriber to its default behavior as implicit.
idle-mode detach
Configures the IDLE mode Detach behavior of a UE.
detach
Defines the Detach procedure while the UE is in IDLE mode.
explicit
Enables the Explicit Detach while a UE is in IDLE mode. The system will page the UE before Detach
procedure is started, and then perform the Explicit Detach procedure. Default: Enabled
procedure is started, and then perform the Explicit Detach procedure. Default: Enabled
implicit
Enables the Implicit Detach while a UE is in IDLE mode. The system never sends any message to the UE
before Detach, and executes the Implicit Detach procedure immediately. Default: Disabled
before Detach, and executes the Implicit Detach procedure immediately. Default: Disabled
Usage
Use this command to set the user-defined policies for session management in this MME service.
Example
The following command sets the Idle Mode Detach policy to Implicit for a user in this MME service:
policy idle-mode detach implicit