Cisco Cisco Packet Data Gateway (PDG)
Peer-Server Configuration Mode Commands
▀ self-point-code
▄ Command Line Interface Reference, StarOS Release 16
7812
self-point-code
This command defines the point-code to identify the SGSN as a peer server.
Product
SGSN
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > SS7 Routing Domain Configuration > Peer-Server Configuration
configure > ss7-routing-domain rd_id variant variant_type > peer-server id server_id
Entering the above command sequence results in the following prompt:
[local]host_name(config-ss7-rd-ss7rd_id-ps-id-peer-server_id)#
Syntax
self-point-code point-code
no self-point-code
point-code
Point-code is an SS7-type address for an element in the SS7 network. Point-codes must be defined in dotted-
decimal format in a string of 1 to 11 digits. Options include:
decimal format in a string of 1 to 11 digits. Options include:
0.0.1 to 7.255.7 for point-code in the ITU range.
0.0.1 to 255.255.255 for point-code in the ANSI range.
0.0.1 to 15.31.255 for point-code in the TTC Range.
a string of 1 to 11 digits in dotted-decimal to represent a point-code in a different range.
no
Removes the self-point-code configuration for this linkset in the peer server.
Important:
Removing the self-point-code will result in the termination of all traffic on this link.
Usage
Use this command to define the point-code to identify the SGSN.
Example
Use the following command to remove the self-point-code definition from the peer-server configuration:
no self-point-code