Cisco Cisco Packet Data Gateway (PDG)
Policy Control Configuration Mode Commands
diameter map ▀
Command Line Interface Reference, StarOS Release 16 ▄
7861
diameter map
This command enables selecting the value to which the USAGE_REPORT and APN_AMBR_MOD_FAILURE Event-
Trigger should be mapped to.
Trigger should be mapped to.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IMS Authorization Configuration > Policy Control
Configuration
Configuration
configure > context context_name > ims-auth-service service_name > policy-control
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-imsa-dpca)#
Syntax
diameter map usage-report { 29 | 26 | 33 }
default diameter map usage-report
usage-report { 29 | 26 | 33 }
Maps the USAGE_REPORT of Event-Trigger AVP to one or a combination of these values.
26 – Event-Trigger 26 will mapped to USAGE_REPORT. Note this will not affect any other Event-
Trigger.
29 – Event-Trigger 29 will mapped to USAGE_REPORT, and 33 to APN_AMBR_MOD_FAILURE.
33 – Event-Trigger 33 will mapped to USAGE_REPORT, and 29 to APN_AMBR_MOD_FAILURE.
default
The default behavior is to configure the Event-Trigger USAGE_REPORT to be mapped to 26.
Usage
The Event-Trigger AVP’s USAGE_REPORT has been given different values in the 3GPP TS 29.212
standard spec. As a result of that, the releases of TS 29.212 are not backward compatible. To address this, this
CLI command has been introduced in Policy Control configuration mode to map the USAGE_REPORT to
either 26/29/33 in order to be flexible enough to interoperate with various operators.
standard spec. As a result of that, the releases of TS 29.212 are not backward compatible. To address this, this
CLI command has been introduced in Policy Control configuration mode to map the USAGE_REPORT to
either 26/29/33 in order to be flexible enough to interoperate with various operators.
TS 29.212 v9.5.0 - USAGE_REPORT (26)
TS 29.212 v9.6.0 - USAGE_REPORT (29)
TS 29.212 v9.7.0 - USAGE_REPORT (33)
If this CLI command
diameter map usage-report 29
is configured in the chassis and PCRF sends 29
event-trigger then on volume threshold breach CCR-U with volume-report and event-trigger 29 will be sent
to the PCRF. Same is the case with the values 26 and 33.
to the PCRF. Same is the case with the values 26 and 33.