Cisco Cisco Packet Data Gateway (PDG)
Policy Control Configuration Mode Commands
endpoint-peer-select ▀
Command Line Interface Reference, StarOS Release 16 ▄
7869
endpoint-peer-select
This command enables Diabase to select the Diameter peers in all failure scenarios.
Product
GGSN
PGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IMS Authorization Configuration > Policy Control
Configuration
Configuration
configure > context context_name > ims-auth-service service_name > policy-control
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-imsa-dpca)#
Syntax
endpoint-peer-select [ on-host-select-failure | on-inactive-host ]
{ default | no } endpoint-peer-select
on-host-select-failure
Specifies to perform server selection at Diabase when the hosts could not be selected by IMS Authorization
application.
application.
on-inactive-host
Specifies to perform server selection at diabase when the hosts selected by application are inactive.
default | no
Default/no behavior is to terminate the call when the hosts could not be selected by application or when the
hosts selected by application are inactive.
hosts selected by application are inactive.
Usage
Use this command to perform server selection at Diabase when the hosts could not be selected by application
or when the hosts selected by the IMS Authorization application is inactive. For example, host table is not
configured in IMSA service, host table is configured but not activated, none of the rows in prefix table match
the subscriber, host template is not associated with IMSA service, host template could not select the hosts.
This CLI command is added in policy control configuration mode to maintain backward compatibility with
the old behavior of terminating the call when server selection fails at application.
or when the hosts selected by the IMS Authorization application is inactive. For example, host table is not
configured in IMSA service, host table is configured but not activated, none of the rows in prefix table match
the subscriber, host template is not associated with IMSA service, host template could not select the hosts.
This CLI command is added in policy control configuration mode to maintain backward compatibility with
the old behavior of terminating the call when server selection fails at application.
Example
The following command enables Diabase to select peers when the hosts selected by application are inactive.
endpoint-peer-select on-inactive-host