Cisco Cisco Packet Data Gateway (PDG)

Seite von 8770
  SGSN PSP Configuration Mode Commands 
sctp-rto-min  ▀   
 
Command Line Interface Reference, StarOS Release 16  ▄  
 
   
8317 
sctp-rto-min 
This command sets the minimum retransmission timeout (RTO) value for the SCTP. 
Product
 
SGSN 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > SS7 Routing Domain Configuration > Peer-Server Configuration > PSP Configuration 
configure > ss7-routing-domain routing_domain_id variant variant_type > peer-server id id 
> psp instance psp_instance 
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-ss7-rd-ss7rd_id-ps-peer-server_id-psp-psp_instance)# 
Syntax
 
sctp-rto-min [ units-10ms ] value 
default sctp-rto-min 
default
 
Resets the 
sctp-rto-min
 to the default of 10 (1 second). 
units-10ms 
 
Including this keyword, before entering a value, enables configuration with finer granuality - in 10 
millisecond units.  
value
 
If the 
units-10ms
 keyword is included, then set the timeout in increments of 10 milliseonds. The value must 
be an integer between 1 and 500. 
If the 
units-10ms
 keyword is not included then set the timeout in increments of 100 milliseconds. The value 
must be an integer between 1 and 50. 
Usage 
Important:
  Before using this command to set a value, you must disassociate the PSP instance with the 
no 
associate 
command. When you have set the value with this command, then use the 
associate
 command to setup a 
new association. 
Use this command to set the minimum time for retransmission before timeout. 
The value set for 
sctp-rto-min
 should be less than or equal to the value set for 
sctp-rto-initial
 
(
sctp-rto-min 
<=
 sctp-rto-initial
Example
 
The following sets the timeout for 2 seconds: